Products > Hardware - Fasteners > 2600 & 2700 Series Camloc Fasteners
To make a complete Camloc fastener select a suitable stud from “Chart A”, this part number is followed by the dash number according to your total panel thickness (in inches) from “Chart B”, e.g. 2600-3. Finally select a suitable receptacle from “Chart C”.
Chart A - Stud Type
MaterialHead StylePart Number
Plated SteelSlotted Dome2600
Stainless Steel2600S
Plated SteelPhillips Dome26S8
Winged Dome2600W
Slotted Csk2700
Phillips Csk27S3
Chart B - Stud Length
Combined Panel ThicknessDash Number
0.03” - 0.059”-1
0.06” - 0.089”-2
0.09” - 0.119”-3
0.12” - 0.149”-4
0.15” - 0.179”-5
0.18” - 0.209”-6
0.21” - 0.239”-7
0.24” - 0.269”-8
0.27” - 0.299”-9
0.30” - 0.329”-10
0.33” - 0.359”-11
0.36” - 0.389”-12
0.39” - 0.419”-13
0.42” - 0.449”-14
Chart C - Receptacle Type
MaterialRivet HolesPart Number
Silicon BronzePlain212-12
Countersunk212-12D
Aluminium AlloyPlain212-12A

Retaining Washers

Washers are required for studs of length -5 and greater.

2600-LW

Solid washer with internal teeth which will hold the stud tight against the outer panel

2600-SW

Split washer which fits just under the bar at the end of the stud, retaining fastener in the outer panel but loose.

Result Page: 1 2 3 Next