 |
A790 Vernier Control This control has a .078” diameter and stainless steel wire core, which can be shortened if required. Knob colour is red, maximum travel 4”. Other colour knobs are available on request. |
 |
A800 Friction Lock Control The A800 friction lock control is a fine quality control made to exacting aircraft standards. Provides positive locking throughout selected power settings by turning the chrome collet locking nut. Unique... |
| American MS Turnbuckle Barrels | |
 |
American Phenolic Pulleys American specification phenolic pulleys fitted with ball bearings. The chart refers to the dimensions (A, B, C, D, E) in the diagram and to the maximum allowable load limit in pounds. |
 |
AN100 Thimbles Made of cadmium plated steel, used to form a sturdy eye end on control cable. |
 |
AN111 Rollers Used in a similar manner to the AN100 thimble (can in fact be slipped inside same) but gives the bale end a precision hole to take a shackle pin or bolt. |
 |
AN486 1/4” UNF Forks Note that AN486-1032 has a 1032 (3/16”) thread. |
 |
AN665 Threaded Clevis Tie Rod Terminals These cadmium plated steel terminals are manufactured to “AN” specifications, with either right or left hand threads. For example: AN665-10L has a 6-40 left hand thread and AN655-34R has a... |
 |
Aurora Rod Ends (Experimental Use Only) All right hand UNF thread. |
| Auster Control Cables | |
| Ball Joints | |
 |
Bellcrank Bearing Bore 1/4”, Flange Diameter 1 5/8” |
| British AGS Turnbuckles |
|
 |
British Female Fork Joints The letter ‘L’ or ‘R’ at the end of the part number denotes a left or right hand thread fork. |
 |
British Pulleys Phenolic pulleys fitted with ball bearings. |
 |
British SP8 Turnbuckles These assemblies are supplied in their component parts. Please see the table below for a breakdown of the parts. Larger sizes and assemblies with non matching ends (i.e. 412 fork one end and 413 the other)... |
 |
Button Dash Control Button type dash controls can be used with many control systems, easily installed. All adjustable parts are metal, which gives a smooth operation. 7/8” dural button on 3/16” diameter shaft,... |
 |
Cable Fairleads |
| Control Cable | |
 |
Nicopress Sleeves and Tools These plain, copper, oval shaped sleeves are used in making eye splices in flexible cable. Sleeves are slipped over the cable and then compressed with the special tool. The 428 series oval sleeves are... |
 |
Plain Shank Rod End Suitable for fitting in tubes. 3/16” bore, 0.323” diameter shank. Alternative to Rose Part RBJ67H. |
 |
Rod End Bearings |
 |
Shackles |
| Swagable Terminals These terminals are made of corrosion resistant steel and when properly swaged to the cable will maintain the minimum rated breaking strength of that cable. |
|
 |
T-Handle Dash Control These controls are manufactured of duralumin and brass. Locks positively, will not vibrate loose. One-fourth turn locks it in any position and will hold up to 200 Ibs. Standard travel is 2 1/2”,... |