For use in medium pressure hydraulic, pneumatic, fuel, oil and coolant systems, conforms to MIL-H-8794. Operating temperatures -65 to +250 degrees fahrenheit. Hose is reinforced with a single wire braid...

Suitable for instrument and vacuum lines only.

This hose is made from an inner tube of seamless, specially formulated synthetic rubber, reinforced with a stainless steel partial inner braid and total cover stainless steel outer braid. Not recommended...

Makes aircraft oil changes easy. The hand actuated valve, when attached to the oil drain port, permits engine oil changes from the ground without removing the engine cowling. The spring loaded E-Z drain...

These mandrels are recommended in the assembly of aircraft hoses as they help avoid damage to the sealing surface and properly support the inner surface

To prevent fluid wicking, the ends of the fire sleeze should be dipped in this solution. Supplied in quart tins.

Manufactured from aircraft quality aluminium and anodised for corrosion protection, this lightweight (180g) rugged unit has been designed to remove oil from the crankcase breather on Lycoming and Continental...

This high quality tacho cap has been machined from L168 aluminium and is chromic anodised for greater protection. Suitable to plug the tacho drive fitting on a Lycoming engine if an electronic tacho drive...

All spin on filters are equipped with an attached installation gasket, those with male threaded studs have thread protectors to avoid damage. Also available element oil filter for earlier type filters.

Used on Microlights and PFA aircraft for some fuel lines.

The purpose of this fire sleeve is not to increase the service temperature of a hose line but to protect the hose from direct fire long enough to allow appropriate action to be taken. This sleeve meets...

Special clamps to seal fire sleeve at hose ends. To install you should use the special pok-kit tool but this is expensive. A satisfactory alternative is to use AGS3925 stainless steel hose clips. (We...

Fibreglass ducting impregnated with red silicone rubber with a spiral copper coated steel wire insert, will withstand temperatures from minus 80°F to over 450°F. We keep the sizes listed in stock....

Ideal for use on hoses to record part numbers and pressure testing dates. Made in soft aluminium.

Skytronics individual screened leads finished in a blue colour. These are a high quality product, original equipment on most aircraft. Full detailed instructions are supplied with every lead together...

These switches provide on and off electrical control of both magnetos on single engine aircraft. The key operated switch mounts from the rear of the instrument panel in a 7/8” diameter hole. All...

Helps eliminate radio interference. Install and connect to the cable leading to the magneto switch in the cockpit. Requires screw MS35206-241 and shake proof washer MS35333-38.

Black rubber hose with fabric reinforcement withstands temperatures up to 250°F and remains flexible down to minus 40°F, longest single length 10 x 30 cms. (10 feet). Replaces MIL-H-6000